Welcome to visit: Dongguan Metal Surface Treatment Technology Co.,Ltd.

WhatsApp Mobile Wechat:+86 18825852529
[Defect resolution] The gravure is worn too fast, what's the matter? How to solve it?
- Categories:Gravure plate technology
- Author:
- Origin:
- Time of issue:2015-03-27 12:30
- Views:
[Defect resolution] The gravure is worn too fast, what's the matter? How to solve it?
- Categories:Gravure plate technology
- Author:
- Origin:
- Time of issue:2015-03-27 12:30
- Views:
Information
【Abstract】There are three main reasons that cause the printing plate to wear too fast, namely, the chrome layer is too soft, the pressure of the doctor blade is too large, and the problem of the plate roller turning dark. How to solve the problem of too fast printing plate wear caused by these three reasons?
【text】
Reason 1: The chrome layer is too soft.
Measures: Re-chrome plating to control the hardness of the chrome layer.
Reason 2: The scraper pressure is too heavy, mechanical pressure is used for illegal operation.
Measures: Reduce the pressure of the squeegee, and do not use mechanical pressure for illegal operations. If you have to use a heavy squeegee due to other printing quality problems, it is recommended to find out the cause of the printing quality problem and find a solution.
Reason three: The eccentricity of the plate roller is large when the plate roller is installed, which leads to running bounce and periodic pressure wear.
Measures: Control the degree of eccentricity of the plate roller, the method depends on the machine speed, and the control is within ±0.1mm below 150m/min.
Previous:
Japan TOKYO Abrasive Sand Net Roll
Technology Center
Previous page
1
Next page
Online Message
客户留言
Description:
COPYRIGHT © 2021 ALL RIGHTS RESERVED Dongguan Metal Surface Treatment Technology Co.,Ltd. Powered by www.300.cn 粤ICP备18106959号